The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

A200S V2 Case 3D Model (For 3D Printing)

£0.00
(No reviews yet) Write a Review

The top case for the A200S V2. 

You can print them at 0.3mm layer height and about 30-60% infill depending on the strength you want. We normally use 3 outer walls and 3 top and bottom layers.

We recommend printing with the big flat part at the bottom and using lots of support for the pillars.

If you need someone to print it for you check out 3D Hubs https://www.3dhubs.com